Tampere University of Technology

TUTCRIS Research Portal

Department of Intelligent Hydraulics and Automation

Research unit: Department

  1. 2012
  2. Published

    Proportional valve control of water-hydraulic systems

    Sairiala, H. & Koskinen, K. T., 2012, Topic water hydraulics, Dutch Fluid Power Conference, Ede, The Netherlands 13th September 2012. Vereniging Platform Hydrauliek, p. 49-63 (Dutch Fluid Power Conference).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientific

  3. Published

    Recent results in energy efficient digital hydraulic valve control

    Huova, M., 2012, Proceedings of the 6th GIM Scientific Workshop, November 7-8, 2012, Tampere, Finland. Huhtala, K. & Uusi-Heikkilä, J. (eds.). Tampere: Tampere University of Technology. Department of Intelligent Hydraulics and Automation, p. 89-94 (GIM Scientific Workshop; vol. 6).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  4. Published

    Semantic Top-Down Modeling of Mechatronics Systems for Sustainable Product Data and Lifecycle Management

    Nykänen, O., Koskinen, K. T., Ranta, P., Salonen, J., Rokala, M., Helminen, M., Nurmi, J., Sairiala, H., Alarotu, V., Aaltonen, J. & Pohjolainen, S., 2012, The 13th Mechatronics Forum International Conference. Proceedings Vol. 3/3. September 17-19 2012, Linz, Austria.. Scheidl, R. & Jacoby, B. (eds.). Linz, Austria: Austrian Center of Competence in Mechatronics (ACCM), p. 792-799 (Mechatronics Forum International Conference).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  5. Published

    Sensor module for hydraulic boom state feedback control

    Honkakorpi, J., Vihonen, J. & Mattila, J., 2012, In : International Journal of Fluid Power. 13, 3, p. 15-23

    Research output: Contribution to journalArticleScientificpeer-review

  6. Published

    Simulation and experimental results of PWM control for Digiltalhydraulics

    Plöckinger, A., Huova, M. & Scheidl, R., 2012, DFP 12, Proceedings of the fifth workshop on digital fluid power, October 24-25, 2012, Tampere, Finland. Laamanen, A. & Linjama, M. (eds.). Tampere: Tampere University of Technology. Department of Intelligent Hydraulics and Automation, p. 133-152 (Workshop on digital fluid power).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  7. Published

    Simulations with fault-tolerant controller software of a digital valve

    Huova, M., Ketonen, M., Alexeev, P., Boström, P., Linjama, M., Walden, M. & Sere, K., 2012, Proceedings of the fifth workshop on digital fluid power, October 24-25, 2012, Tampere, Finland. Laamanen, A. & Linjama, M. (eds.). Tampere: Tampere University of Technology. Department of Intelligent Hydraulics and Automation, p. 223-242 (Digital fluid power).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  8. Published

    Unified Framework for Rapid Prototyping of Linux based Real-Time Controllers with Matlab and Simulink

    Oftadeh, R., Aref, M. M., Ghabcheloo, R. & Mattila, J., 2012, IEEE/ASME International Conference on Advanced Intelligent Mechatronics, AIM 2012, Ambassador Hotel, July 11-14, Kaohsiung, Taiwan. Piscataway, NJ: Institute of Electrical and Electronics Engineers IEEE, p. 274 - 279 (IEEE/ASME International Conference on Advanced Intelligent Mechatronics).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  9. Published

    Voiteluöljyn online- ja inline-kunnonvalvonta, "Uusia tapoja ja menetelmiä öljyn kunnon ja vaihtovälin määrittelemiseksi"

    Elo, L. & Rinkinen, J., 2012, Voiteluaineanalyysit mittaavan kunnossapidon työkaluna, AEL -seminaari 29.8.2012. Helsinki: Elinkeinoelämän koulutuspalvelut, p. 1-14 14 p.

    Research output: Chapter in Book/Report/Conference proceedingConference contributionProfessional

  10. 2011
  11. Published

    Impedance Control of Redundant Manipulators

    Muhammad, A., 4 Nov 2011, Tampere University of Technology. 169 p. (Tampere University of Technology. Publication; vol. 986)

    Research output: Book/ReportDoctoral thesisMonograph

  12. Published

    Feature Extraction and Self-Organizing Maps in Condition Monitoring of Hydraulic Systems

    Krogerus, T., 28 Jan 2011, Tampere: Tampere University of Technology. 126 p. (Tampere University of Technology. Publication; vol. 949)

    Research output: Book/ReportDoctoral thesisMonograph

  13. Published

    2008-2010 Host Activities Related to DTP2 Test Facility Operation and Upgrade Preparation

    Siuko, M., Järvenpää, J. & Mattila, J., 2011, Valtion teknillinen tutkimuslaitos. 11 p. (VTT Publications; vol. 764)

    Research output: Book/ReportCommissioned reportProfessional

  14. Published

    A Case Study on Effects of Remote Control and Control System Distribution in Hydraulic Mobile Machines

    Uusisalo, J., 2011, Tampere: Tampere University of Technology. 111 p. (Tampere University of Technology. Publication; vol. 960)

    Research output: Book/ReportDoctoral thesisMonograph

  15. Published

    Adaptive dead zone compensation of proportional mobile valve

    Kivelä, T. & Mattila, J., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Sairala, H. & Koskinen, K. T. (eds.). Tampere: Scandinavian International Conference on Fluid Power, p. 411-422 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 3).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  16. Published

    Advantage of redundancy in the controllability of remote handling manipulator

    Muhammad, A., Mattila, J., Vilenius, M., Siuko, M. & Semeraro, L., 2011, In : Fusion Engineering and Design. 86, 9-11, p. 1882-1885

    Research output: Contribution to journalArticleScientificpeer-review

  17. Published

    Aircraft Hydraulic System Fault Finding and Troubleshooting Using On-Line Particle Counters

    Aaltonen, J., Alarotu, V. & Koskinen, K. T., 2011, The Eight International Conference on Condition Monitoring and Machinery Failure Prevention Technologies, 20-22 June 2011, Cardiff, Wales. Northamption: British Institute of Non-destructive Testing, p. 1275-1282 (International Conference on Condition Monitoring and Machinery Failure Prevention Technologies; vol. 2).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  18. Published

    Aircraft hydraulic system model integration to fligh simulation model

    Hietala, J-P., Aaltonen, J., Koskinen, K. T. & Vilenius, M., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Tampere: Scandinavian International Conference on Fluid Power, p. 271-280 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 1).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  19. Published

    Analysis and control of a single leg for hydraulically actuated quadruped robot

    Xia, Y., Aaltonen, J. & Koskinen, K. T., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Tampere: Scandinavian International Conference on Fluid Power, p. 149-160 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 1).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  20. Published

    Analysis of effect of remote control on usability of hydraulic mobile machines

    Uusisalo, J. & Huhtala, K., 2011, Proceedings of the 8th JFPS International Symposium on Fluid Power, Okinawa 2011, October 25-28, 2011, Okinawa, Japan. Okinawa: JFPS international Symposium on Fluid Power, p. 688-695 (International Symposium on Fluid Power JFPS).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  21. Published

    Analysis of the new architecture proposal for the CMM control system

    Heikkilä, L., Saarinen, H., Aha, L., Viinikainen, M., Mattila, J., Hahto, A., Siuko, M. & Semeraro, L., 2011, In : Fusion Engineering and Design. 86, 9-11, p. 2071-2074

    Research output: Contribution to journalArticleScientificpeer-review

  22. Published

    An implementation of a semantic, web-based virtual machine laboratory prototyping environment

    Salonen, J., Nykänen, O., Ranta, P., Nurmi, J., Helminen, M., Rokala, M., Palonen, T., Alarotu, V., Koskinen, K. & Pohjolainen, S., 2011, In : Lecture Notes in Computer Science. 7032, p. 221-236

    Research output: Contribution to journalArticleScientificpeer-review

Previous 1 2 3 4 5 6 7 8 ...17 Next

ID: 21447