Tampere University of Technology

TUTCRIS Research Portal

Department of Intelligent Hydraulics and Automation

Research unit: Department

  1. Conference contribution › Scientific › Peer-reviewed
  2. Published

    Comparison of digital hydraulic and traditional servo system in demanding water hydraulic tracking control

    Linjama, M., Seppälä, J., Mattila, J. & Vilenius, M., 2008, Fluid Power and Motion Control FPMC 2008, 10-12 September 2008, Bath, UK. Johnston, D. N. & Plummer, A. R. (eds.). p. 393-403

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  3. Published

    Comparison of measured and predicted dynamic properties of different commercial hydraulic fluids

    Karjalainen, J-P., Karjalainen, R., Huhtala, K. & Vilenius, M., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Sairala, H. & Koskinen, K. T. (eds.). Tampere: Scandinavian International Conference on Fluid Power, p. 281-296 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 2).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  4. Published

    Comparison of slipper structures in water hydraulic axial piston pump

    Rokala, M. & Koskinen, K. T., 2010, 6th FPNI-PhD Symposium, June 15-19, 2010, West Lafayette, USA.

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  5. Published

    Comparison of tracking controllers of hydraulic cylinder drive by simulations

    Virvalo, T., 2008, Proceedings of the 7th International Conference on Machine Automation ICMA2008, Service Robotics and Mechatronics, September 24-26, 2008, Awaji, Japan. p. 37-40

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  6. Published

    Comparison of vibration and pressure signals for fault detection on water hydraulic proportional valve

    Krogerus, T., Pietikäinen, J. & Koskinen, K. T., 2008, Proceedings of the 7th JFPS International Symposium on Fluid Power, Toyama, September 15-18, 2008. Tanaka, Y. (ed.). p. 691-696

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  7. Published

    Condition monitoring and in-line maintenance of oil in circulating lubrication system

    Rinkinen, J., 2010, Proceedings of the 3rd International Seminar Maintenance, Condition Monitoring and Diagnostics, September 29-30, 2010, Pohto, Oulu, Finland. Lahdelma, S. & Palokangas, K. (eds.). p. 136-151

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  8. Published

    Contract-based design in controller development and its evaluation

    Boström, P., Plaska, M., Huova, M., Linjama, M., Heikkilä, M., Sere, K. & Walden, M., 2009, Nodes 09: Nordic workshop and doctoral symposium on Dependability and security, Linköping, Sweden, April 27, 2009. Asplund, M., Nadjm-Tehrani, S. & Petre, L. (eds.). p. 21-27

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  9. Published

    Control and actuator synchronization of water hydraulic 6-DOF motion platform

    Sairiala, H., Rokala, M. & Koskinen, K. T., 2008, Proceedings of the 51st National Conference on Fluid Power March 12-14, 2008, IFPE 2008, Las Vegas, USA. p. 345-350

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  10. Published

    Controller design of digital hydraulic flow control valve

    Huova, M., Plaska, M., Siivonen, L., Linjama, M., Walden, M., Vilenius, M. & Sere, K., 2009, The 11th Scandinavian International Conference on Fluid Power SICFP'09, Linköping, Sweden, June 2-4 2009. p. 15 p

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  11. Published

    Control of three-chamber cylinder with digital valve system

    Huova, M. & Laamanen, A., 2009, Proceedings of The Second Workshop on Digital Fluid Power 12-13 November 2009, Linz, Austria. Scheidl, R. & Winkler, B. (eds.). p. 94-105 12 p.

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  12. Published

    Coordinated Control of Hydraulic Mobile Manipulators

    Ghabcheloo, R. & Huhtala, K., 2012, The 2nd IFAC Workshop on Multivehicle Systems, MVS, 3-4 October 2012, Espoo, Finland. Halme, A. & Suomela, J. (eds.). Laxenburg: The International Federation of Automatic Control IFAC, p. 37-42 (IFAC Workshop on Multivehicle Systems; vol. 2, no. Part 1).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  13. Published

    Dependable Control Systems Design and Evaluation

    Alho, P. & Mattila, J., 2011, Conference on Systems Engineering Research (CSER) 2011 Redondo Beach, California, USA, April 15-16, 2011.. Redondo Beach, CA: CSER 2011, (Conference on Systems Engineering Research CSER).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  14. Published

    Design and implementation of digital hydraulic synchronization and force control system

    Linjama, M., Hopponen, V., Ikonen, A., Rintamäki, P., Vilenius, M. & Pietola, M., 2009, The 11th Scandinavian International Conference on Fluid Power SICFP'09, Linköping, Sweden, June 2-4 2009. p. 13 p

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  15. Published

    Detecting and eliminating the measurement error caused by free air in aircraft hydraulic system on-line particle counting

    Aaltonen, J. & Koskinen, K. T., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Tampere: Scandinavian International Conference on Fluid Power, p. 229-240 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 1).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  16. Published

    Detection and isolation of leakage and valve faults in hydraulic systems in varying loading conditions

    Nurmi, J., 2011, Proceedings of the 5th GIM Scientific Workshop at Aalto University School of Electrical Engineering 29.-30.11.2011. Espoo: Aalto University, p. 80-88 (GIM Scientific Workshop).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  17. Published

    Detection of errors and failures using intelligent interface during a teleoperation process on skid steered mobile machine

    Javier, M., Karhu, O. I., Uusisalo, J. R. A. & Huhtala, K. J., 2008, 3rd IEEE Conference on Industrial Electronics and Applications ICIEA 2008, 3-5 June 2008, Singapore. p. 326-330

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  18. Published

    Development of an intelligent control user interface for autonomous machines

    Järä, J. & Hyvönen, M., 2009, The Second Workshop on Generic Intelligent Machines, May 14-15, 2009, Tampere University of Technology, Tampere, Finland. Huhtala, K. & Uusi-Heikkilä, J. (eds.). p. 8 p

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  19. Published

    Development of a virtual environment for promoting safety in machine maintenance

    Lind, S., Leino, S-P., Viitaniemi, J., Helin, K., Multanen, P., Mäkiranta, A. & Heikkilä, J., 2008, Proceedings of the 6th International Conference on Occupational Risk Prevention, ORP´2008, A Coruña, Galicia, Spain, May 14th, 15th & 16th, 2008. Mondelo, P., Karwowski, W., Saarela, K., Hale, A. & Occipinti, E. (eds.). p. 14 p

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  20. Published

    Development of water hydraulic manipulator for the remote handling of heavy duty components

    Muhammad, A., Valkama, P., Siuko, M., Mattila, J. & Vilenius, M., 2010, 7th International Fluid Power Conference (7th IFK), 22-24 March 2010, Aachen, Germany. p. 1-12 12 p.

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  21. Published

    Development of water hydraulic remote handling system for divertor maintenance of ITER

    Muhammad, A., Esque, S., Mattila, J., Tolonen, M., Nieminen, P., Linna, O., Vilenius, M., Siuko, M., Palmer, J. & Irving, M., 2007, Proceedings of the 22nd IEEE/NPSS Symposium on Fusion Engineering - SOFE 07, Albuquerque, New Mexico, June 17-21, 2007. p. 4 p

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

Previous 1 2 3 4 5 6 7 8 ...17 Next

ID: 21447