Tampere University of Technology

TUTCRIS Research Portal

Department of Intelligent Hydraulics and Automation

Research unit: Department

  1. A4 Article in a conference publication
  2. Published

    Fault Tolerance with digital Hydraulic Valve System

    Siivonen, L., Linjama, M. & Vilenius, M., 2011, The Eight International Conference on Condition Monitoring and Machinery Failure Prevention Technologies, 20-22 June 2011, Cardiff, Wales. Northamption: British Institute of Non-destructive Testing, p. 1250-1262 (International Conference on Condition Monitoring and Machinery Failure Prevention Technologies; vol. 2).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  3. Published

    Model-based pressure control with digital valve system

    Linjama, M. & Lahtinen, J., 2011, The Fourth Workshop on Digital Fluid Power, 21st-22nd November, 2011, Linz, Austria. Linz: DFP-Workshops, p. 26-38 (Workshop on Digital Fluid Power; vol. 4).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  4. Published

    Research of optimizing the prime mover and hydraulics of mobile machines

    Backas, J., 2011, GIM - Generic Intelligent Machines, The 4th GIM Scientific Workshop, January 18-19, 2011, Tampere University of Technology, Tampere, Finland. Tampere: Tampere University of Technology, p. 1-5 5 p. (GIM Scientific Workshop; vol. 4).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  5. Published

    GIMsim: Hardware in the loop simulator for autonomous hydraulic mobile machines

    Ghabcheloo, R., 2011, GIM - Generic Intelligent Machines, The 4th GIM Scientific Workshop, January 18-19, 2011, Tampere University of Technology, Tampere, Finland. Tampere: Tampere University of Technology, p. 1-13 13 p. (GIM Scientific Workshop; vol. 4).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  6. Published

    Service-oriented ad-hoc method for unforeseen scenarios

    Hahto, A., Rasi, T., Kivelä, T., Honkakorpi, J. & Mattila, J., 2011, Fifth International Workshop on Robotics for risky interventions and Environmental Surveillance-Maintenance 5th IARP RISE’2011, 20-22 June, C-ELROB 2011, 21-24 June, Brussels – Leuven. Leuven: IARP, p. 1-6 6 p. (International Workshop on Robotics for Risky Interventions and Environmental Surveillance-Maintenance IARP RISE, C-ELROB).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  7. Published

    Development process of control system

    Ahopelto, M., 2011, GIM - Generic Intelligent Machines, The 4th GIM Scientific Workshop, January 18-19, 2011, Tampere University of Technology, Tampere, Finland. Tampere: Tampere University of Technology, p. 1-7 7 p. (GIM Scientific Workshop; vol. 4).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  8. Published

    Comparison between an aircraft speed brake actuator high order linear model and a semi-empirical non-linear model in real time simulation

    Hietala, J-P., Aaltonen, J., Koskinen, K. T. & Vilenius, M., 2011, AST 2011, 3rd International Workshop on Aircraft System Technologies, March 31 - April 1, 2011, Hamburg, Germany. Hamburg: Hamburg University of Technology, p. 65-71 (International Workshop on Aircraft System Technologies AST; vol. 3).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  9. Published

    Virtual machine laboratory based on m1-technology

    Helminen, M., Palonen, T., Rokala, M., Ranta, P., Mäkelä, T. & Koskinen, K. T., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Tampere: Scandinavian International Conference on Fluid Power, p. 321-334 (Scandinavian International Conference on Fluid Power SICFP; vol. 12).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  10. Published

    Displacement controlled machines

    Ahola, V., 2011, Proceedings of the 5th GIM Scientific Workshop at Aalto University School of Electrical Engineering 29.-30.11.2011. Espoo: Aalto University, p. 124-131 (GIM Scientific Workshop).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  11. Published

    Self contained hydraulic module for cylinder driven applications

    Westerlund, S., Mäkinen, E. & Sinivaara, M., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Sairala, H. & Koskinen, K. T. (eds.). Tampere: Scandinavian International Conference on Fluid Power, p. 291-300 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 3).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  12. Published

    A reduced-order unscented kalman filter independent of loading conditions for leakage fault detection and isolation in hydraulic systems

    Nurmi, J. & Mattila, J., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Sairala, H. & Koskinen, K. T. (eds.). Tampere: Scandinavian International Conference on Fluid Power, p. 57-74 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 4).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  13. Published

    Analysis of effect of remote control on usability of hydraulic mobile machines

    Uusisalo, J. & Huhtala, K., 2011, Proceedings of the 8th JFPS International Symposium on Fluid Power, Okinawa 2011, October 25-28, 2011, Okinawa, Japan. Okinawa: JFPS international Symposium on Fluid Power, p. 688-695 (International Symposium on Fluid Power JFPS).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  14. Published

    Remote support for maintenance tasks by the use of Augmented Reality: the ManuVAR project

    Azpiazu, J., Siltanen, S., Multanen, P., Mäkiranta, A., Barrena, N., Diez, A., Agirre, J. & Smith, T., 2011, Proceedings of the 9th Congress on Virtual Reality Applications, CARVI 2011. San Sebastian: Tecnalia, p. 1-6 6 p. (Congress on Virtual Reality Applications CARVI; vol. 9).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  15. Published

    Status of DTP2 - Test Facility for ITER Divertor Maintenance

    Salminen, K., Siuko, M., Karjalainen, J., Sibois, R. & Mattila, J., 2011, European Nuclear Young Generation Forum, ENYGF 2011, 17.5.-22.5.2011, Praha. Prague: ENYGF, p. 1-6 6 p. (European Nuclear Young Generation Forum ENYGF).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  16. Published

    Testing of data analysis process in hydraulic forklift

    Krogerus, T. & Koskinen, K. T., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Sairala, H. & Koskinen, K. T. (eds.). Tampere: Scandinavian International Conference on Fluid Power, p. 105-234 130 p. (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 3).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  17. Published

    Dependable Control Systems Design and Evaluation

    Alho, P. & Mattila, J., 2011, Conference on Systems Engineering Research (CSER) 2011 Redondo Beach, California, USA, April 15-16, 2011.. Redondo Beach, CA: CSER 2011, (Conference on Systems Engineering Research CSER).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  18. Published

    Recent advancements in miniature valve development

    Karvonen, M., Ketonen, M., Linjama, M. & Puumala, V., 2011, The Fourth Workshop on Digital Fluid Power, 21st-22nd November, 2011, Linz, Austria. Linz: DFP-Workshops, p. 90-103 14 p. (Workshop on Digital Fluid Power; vol. 4).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  19. Published

    Adaptive dead zone compensation of proportional mobile valve

    Kivelä, T. & Mattila, J., 2011, The Twelfth Scandinavian International Conference on Fluid Power, SICFP'11, May 18-20, 2011, Tampere, Finland. Sairala, H. & Koskinen, K. T. (eds.). Tampere: Scandinavian International Conference on Fluid Power, p. 411-422 (Scandinavian International Conference on Fluid Power SICFP; vol. 12, no. 3).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  20. Published

    Autonomous fleet management utilizing OpenSplice DDS

    Rasi, T., 2011, Proceedings of the 5th GIM Scientific Workshop at Aalto University School of Electrical Engineering 29.-30.11.2011. Espoo: Aalto University, p. 88-102 15 p. (GIM Scientific Workshop).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

  21. Published

    Utilization of R&D Simulators to Support the Maintenance of Mobile Work Machines

    Multanen, P. & Hyvönen, M., 2011, The Eight International Conference on Condition Monitoring and Machinery Failure Prevention Technologies, 20-22 June 2011, Cardiff, Wales. Northamption: British Institute of Non-destructive Testing, p. 1263-1274 (International Conference on Condition Monitoring and Machinery Failure Prevention Technologies; vol. 2).

    Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

Previous 12 3 4 5 6 7 8 9 ...17 Next

ID: 21447