Tampere University of Technology

TUTCRIS Research Portal

3D interfacial debonding during microbond testing: Advantages of local strain recording

Research output: Contribution to journalArticleScientificpeer-review

Details

Original languageEnglish
Article number108163
Number of pages9
JournalComposites Science and Technology
Volume195
DOIs
Publication statusPublished - 10 Apr 2020
Publication typeA1 Journal article-refereed

Abstract

The microbond (MB) test is the most widely adopted micromechanical test to characterize fibre matrix interfaces but typically lacks reliability and output for determining multi-parameter interface models. In the current research, the MB test is enhanced by incorporating Fibre Bragg Grating (FBG) sensors for local fibre strain monitoring. Strain-force data is used to analyse and validate the type and paramter values of a cohesive zone modelling (CZM) basis in the three-dimensional interface damage model. For the prepared epoxy resin droplets, that are used as a benchmark case, a bi-linear CZM traction-separation law is fitted for each droplet. The results confirm the selection of maximum FBG strain, force–strain profile with the two primary peaks in the force–strain derivative, and the peak force to be valid for proper interface characterization. The analysis
of the performed tests clearly reveal the droplet fracture process to consist of four distinct stages. Only after the first stage, interfacial crack propagation independent of the point on perimeter is achieved. Full debonding occurs during the fourth stage.

Keywords

  • Glass fibres, Finite element analysis (FEA), Cohesive zone modelling, Debonding, Interface

Publication forum classification

Field of science, Statistics Finland