Tampere University of Technology

TUTCRIS Research Portal

Dispenser system for nanocellulose 3D printing

Research output: Chapter in Book/Report/Conference proceedingConference contributionProfessional

Details

Original languageEnglish
Title of host publicationAutomaatiopäivät22 Proceedings
PublisherSuomen Automaatioseura
Pages1-6
Number of pages6
Publication statusPublished - 2017
Publication typeD3 Professional conference proceedings
EventAutomaatioseminaari - , Finland
Duration: 1 Jan 1980 → …

Conference

ConferenceAutomaatioseminaari
CountryFinland
Period1/01/80 → …

Abstract

A 3D-printed stepper motor dispenser assembly for a 10ml plastic syringe was constructed. This dispenser assembly was used to run a set of calibration experiments to evaluate its suitability to dose nanocellulose mass. The control of the dosing was done with a Labview software along with an Arduino Uno board. A set of dosing trials was conducted with three different dosing speeds and two different dosing volumes to verify the accuracy and repeatability of the constructed system in the nanocellulose mass dosing. The average dosing accuracy of the system was estimated to be at acceptable level for the application.

Keywords

  • 3D printing, nanocellulose, dispenser, syringe

Downloads statistics

No data available