Tampere University of Technology

TUTCRIS Research Portal

Identification of three-phase grid impedance in the presence of parallel converters

Research output: Contribution to journalArticleScientificpeer-review

Details

Original languageEnglish
Article number2674
JournalEnergies
Volume12
Issue number14
DOIs
Publication statusPublished - 2019
Publication typeA1 Journal article-refereed

Abstract

Grid impedance is an important parameter which affects the control performance of grid-connected power converters. Several methods already exist for optimizing the converter control system based on knowledge of grid impedance value. Grid impedance may change rapidly due to fault or disconnection of a transmission line. Therefore, online grid identification methods have been recently proposed to have up-to-date information about the grid impedance value. This is usually done by perturbing the converter output current and measuring the response in output voltage. However, any parallel converters connected to the same interface point will cause errors, since the measured current differs from the current that is flowing through the grid interface point. This paper points out challenges and errors in grid impedance identification, caused by parallel converters and their internal control functions, such as grid-voltage support. Experimental grid-impedance measurements are shown from the power hardware-in-the-loop setup developed at DNV-GL Flexible Power Grid Lab.

Keywords

  • DC–AC power converters, Grid impedance identification, Power hardware-in-the-loop

Publication forum classification