Tampere University of Technology

TUTCRIS Research Portal

The Impact of LED Lighting Systems to the Power Quality and Recommendations for Installation Methods to Achieve the Expected Energy Efficiency

Research output: Chapter in Book/Report/Conference proceedingConference contributionScientificpeer-review

Details

Original languageEnglish
Title of host publication25th International Conference on Electricity Distribution
PublisherCIRED
Number of pages5
ISBN (Electronic)978-2-9602415-0-1
Publication statusPublished - Jun 2019
Publication typeA4 Article in a conference publication
EventInternational Conference on Electricity Distribution - IFEMA Convention Center, Madrid, Spain
Duration: 3 Jun 20196 Jun 2019
Conference number: 25
http://www.cired2019.org/

Publication series

NameCIRED conference proceedings
ISSN (Electronic)2032-9644

Conference

ConferenceInternational Conference on Electricity Distribution
Abbreviated titleCIRED 2019
CountrySpain
CityMadrid
Period3/06/196/06/19
Internet address

Abstract

The experimental study of the lighting system influence on the power quality has been performed. The effect of the fluorescent tube lights (FTL) with magnetic and electronic ballasts as well as the LED lights from four companies are compared. It is very usual to replace only the FTL tube to LED tube without removing the additional capacitors. According to the presented results, the expected increase in energy efficiency and power quality is not achieved. The produced reactive power is significant with the defective replacement practice. The issue is accelerated with the continuous reduction of inductive loads and the increase of the capacitive reactive power production. When replacing old FTLs with LEDs, the protection and the start-up transient must to be considered. The protection device may require update, for example slower circuit breaker. If no updates for the supply side are made, there may be a need to reduce the amount of lights when FTLs are replaced with LEDs. According to the measurements, LEDs are remarkable factor in the change of capacitive reactive power production. In the future, there should be more detailed instructions and requirements for the lighting system renovation. For example, the installation instructions should include the removal of the capacitors. However, electromagnetic compatibility of the modified lighting equipment cannot be ensured straightforwardly. The best practice for lighting update is to change the whole luminaire. At the moment, this is the only way to ensure the designed operation.

Publication forum classification

Downloads statistics

No data available