A 0.5-6MHz Active-RC LPF with Fine Gain Steps Using Binary Interpolated Resistor Banks
Tutkimustuotos › › vertaisarvioitu
Yksityiskohdat
Alkuperäiskieli | Englanti |
---|---|
Sivut | 1328-1331 |
Sivumäärä | 4 |
Julkaisu | IEICE TRANSACTIONS ON ELECTRONICS |
Vuosikerta | E94-C |
Numero | 8 |
DOI - pysyväislinkit | |
Tila | Julkaistu - elokuuta 2011 |
OKM-julkaisutyyppi | A1 Alkuperäisartikkeli |
Tiivistelmä
This paper proposes an active-RC filter that achieves a wide pseudo-continuous bandwidth-tuning range and a wide gain range with fine steps using a novel switched resistor architecture. A channelselection filter with the proposed resistor bank is designed for a multi-mode mobile-TV receiver with the 6th order Chebyshev-I topology. The bandwidth, 0.5-6 MHz with 5% steps, supports multiple mobile-TV standards with sufficient margins for process and temperature variations. The filter also accomplishes a 30-dB variable gain range with 6-dB steps, and it relaxes the dynamic range requirement of a succeeding programmable gain amplifier. The power consumption of the filter, 3.4-5.0mW, is adjustable according to the bandwidth and the signal level. The filter was fabricated with on-chip bandwidth-calibration circuitry in 0.18-μm CMOS and occupied 0.81mm2.