A concept for defining the mixed-mode behaviour of tough epoxy film adhesives by single specimen design
Tutkimustuotos › › vertaisarvioitu
Yksityiskohdat
Alkuperäiskieli | Englanti |
---|---|
Sivut | 1982-1999 |
Sivumäärä | 18 |
Julkaisu | Journal of Adhesion Science and Technology |
Vuosikerta | 34 |
Numero | 18 |
DOI - pysyväislinkit | |
Tila | Julkaistu - 2020 |
OKM-julkaisutyyppi | A1 Alkuperäisartikkeli |
Tiivistelmä
Fracture modes I and II interact in mixed-mode loading conditions, and the interaction is typically taken into account using a mixed-mode fracture criterion. In this work, a concept for defining the criterion is developed through an experimental-numerical simulation analysis. The mixed-mode behaviour for the criterion is tested and analysed with a single specimen design. The design of the specimen simplifies the measurement when complex test arrangements and preparations for various specimen geometries are excluded in practice. Here, the mixed-mode fracture behaviour of the specimen is analysed in detail using digital image correlation (DIC). The DIC data are used in collaboration with a finite element–based crack onset analysis, including the virtual crack closure technique, in order to consider the typical simplifications and their effects on the mixed-mode criterion. As a benchmark case, the fracture criterion is determined for an epoxy film adhesive FM 300-2 using the developed approach. The developed approach was shown to be feasible and effective for defining the mixed-mode fracture criterion. The determined Power law criterion’s exponents were below unity, which points out that the common (presumed) exponent values in the current literature are actually unconservative.