Angle Estimation for Robotic Arms on Floating Base Using Low-Cost IMUS
Tutkimustuotos › › vertaisarvioitu
Yksityiskohdat
Alkuperäiskieli | Englanti |
---|---|
Otsikko | 2018 IEEE International Conference on Robotics and Automation (ICRA) |
Kustantaja | IEEE |
Sivut | 1458-1465 |
Sivumäärä | 8 |
ISBN (elektroninen) | 978-1-5386-3081-5 |
ISBN (painettu) | 978-1-5386-3082-2 |
DOI - pysyväislinkit | |
Tila | Julkaistu - toukokuuta 2018 |
OKM-julkaisutyyppi | A4 Artikkeli konferenssijulkaisussa |
Tapahtuma | IEEE INTERNATIONAL CONFERENCE ON ROBOTICS AND AUTOMATION - Kesto: 1 tammikuuta 1900 → 1 tammikuuta 2000 |
Julkaisusarja
Nimi | |
---|---|
ISSN (elektroninen) | 2577-087X |
Conference
Conference | IEEE INTERNATIONAL CONFERENCE ON ROBOTICS AND AUTOMATION |
---|---|
Ajanjakso | 1/01/00 → 1/01/00 |
Tiivistelmä
An algorithm that uses low-cost inertial measurement units (IMUs) for estimating link angles for floating base robotic platforms is proposed. Each link has four IMUs attached on its surfaces, and an Extended Kalman Filter (EKF) and a Complementary Filter (CF) are used for fusing the sensors' data. The algorithm is validated with a commercial mobile working machine, which consist of six degrees-of-freedom (DOF) wheeled base platform, and a 3-DOF hydraulic anthropomorphic arm. Although there are vibrational disturbances from the machine's diesel engine and deformation of the links themselves, the measured results from the planar motion of a floating base hydraulic arm show that the accuracy of the angle estimation is impressively less than 1 degree in the root mean square (RMS) error.
Tutkimusalat
Julkaisufoorumi-taso
Tilastokeskuksen tieteenalat
Latausten tilastot
Ei tietoja saatavilla