TUTCRIS - Tampereen teknillinen yliopisto

TUTCRIS

Effect of tempering on the impact-abrasive and abrasive wear resistance of ultra-high strength steels

Tutkimustuotosvertaisarvioitu

Yksityiskohdat

AlkuperäiskieliEnglanti
JulkaisuWear
Vuosikerta440-441
DOI - pysyväislinkit
TilaJulkaistu - 15 joulukuuta 2019
OKM-julkaisutyyppiA1 Alkuperäisartikkeli

Tiivistelmä

Tempering is an essential part in the fabrication of ultra-high strength steels and it is also widely applied in the processing of wear-resistant steels. In this paper, the effects of different tempering temperatures on the impact-abrasive and abrasive wear properties of martensitic ultra-high strength steels were studied. A novel press-hardening steel with carbon content of 0.4 wt% was received in hot-rolled condition and further austenitized, water-quenched and tempered for 2 h at different temperatures (150–400 °C). Tensile strength values up to 2200MPa and hardness exceeding 650HV were measured. Wear testing was done with impact-abrasive impeller-tumbler and abrasive dry-pot application-oriented test methods simulating mining and mineral handling environments. A laboratory rolled 600HB steel and a commercial 500HB grade wear-resistant steel were included for comparison. The wear surfaces and cross-sections of the samples were thoroughly characterized. Both testing methods produced highly deformed surface layers and strong work-hardening. Wear performance was mainly controlled by the initial hardness of the steels, but differences were found in the highly work-hardened surfaces of the steels.