TUTCRIS - Tampereen teknillinen yliopisto

TUTCRIS

Nanocluster Aerosol Emissions of a 3D Printer

Tutkimustuotosvertaisarvioitu

Yksityiskohdat

AlkuperäiskieliEnglanti
Sivut13618−13628
Sivumäärä11
JulkaisuEnvironmental Science and Technology
Vuosikerta53
Numero23
DOI - pysyväislinkit
TilaJulkaistu - 7 marraskuuta 2019
OKM-julkaisutyyppiA1 Alkuperäisartikkeli

Tiivistelmä

Many studies exist that characterize the aerosol emissions from fused filament fabrication three-dimensional (3D) printers. However, nanocluster aerosol (NCA) particles, that is particles in a size range under 3 nm, are rarely studied. The purpose of this study was to characterize the NCA emissions and the contribution of NCA to the total particle number emissions from a 3D printer. We used a particle size magnifier and a scanning mobility particle sizer to measure the time evolution of particle size distribution, which was used to calculate the average NCA emission rates during a printer operation in a chamber. The NCA emission rates ranged from 1.4 × 106 to 7.3 × 109 s-1 depending on the applied combination of filament material and nozzle temperature, showing increasing emission with increasing temperature. The NCA emissions constitute from 9 to 48% of the total emissions, that is, almost half of the particle emissions may have been previously neglected. Therefore, it is essential to include the low NCA size range in, for example, future 3D-printer-testing protocols, emission measurement standards, and risk management measures.

!!ASJC Scopus subject areas

Julkaisufoorumi-taso

Tilastokeskuksen tieteenalat