TUTCRIS - Tampereen teknillinen yliopisto

TUTCRIS

Numerical modeling of the tool-rock penetration process using FEM coupled with SPH technique

Tutkimustuotosvertaisarvioitu

Yksityiskohdat

AlkuperäiskieliEnglanti
Artikkeli107008
Sivumäärä14
JulkaisuJOURNAL OF PETROLEUM SCIENCE AND ENGINEERING
Vuosikerta189
DOI - pysyväislinkit
TilaJulkaistu - 2020
OKM-julkaisutyyppiA1 Alkuperäisartikkeli

Tiivistelmä

The numerical simulation of penetration into rock is an important tool to gain insights into rock drilling mechanisms, since it can be exploited as an alternative to the expensive field testing. This research aims to present an innovative computer simulation of rock penetration process on the basis of the finite element method (FEM) coupled with smoothed particle hydrodynamics (SPH). An advanced material model, namely the Karagozian and Case Concrete (KCC) model, was employed for this purpose. The Punch Penetration test (PPT) was carried out on a medium strength sandstone for validating the numerical method. The comparison of the numerical and experimental results obtained concluded that the FEM coupled with SPH method in conjunction with the fully calibrated KCC material model is a reliable method for the study of rock penetration due to its ability to deal with large deformations and its realistic constitutive modeling. The modeling approach was finally applied to estimate the required force to penetrate an offshore reservoir rock block under the in-situ confining pressure with a double conical tool up to 5 mm depth. The effective stresses in sedimentary basins of Agosta and Dosso Campus at a depth of 3000 m below the seabed are considered as the confining pressures of this study.

Tutkimusalat

Julkaisufoorumi-taso

Tilastokeskuksen tieteenalat