Real-time stability analysis and control of multi-converter systems by using MIMO-identiﬁcation techniques
Tutkimustuotos › › vertaisarvioitu
|Julkaisu||IEEE Transactions on Power Electronics|
|Varhainen verkossa julkaisun päivämäärä||15 heinäkuuta 2018|
|DOI - pysyväislinkit|
|Tila||Julkaistu - huhtikuuta 2019|
characteristics of an interconnected system can be effectively analyzed using bus-impedance measurement. Studies have presented online measurement techniques where the bus impedance is obtained by combining together the measurements of input and output impedances of single converters in the system. Since the converters are coupled, the presented measurement techniques require several measurement cycles in order to sequentially measure the individual impedances to be combined to obtain the overall bus impedance. This paper presents a measurement technique based on injection of orthogonal binary sequences. Applying this method, all the impedances in the system can be simultaneously measured during one measurement cycle. Therefore, the overall measurement time of the bus impedance is reduced compared to conventional measurement techniques. Furthermore, the method guarantees that the system dynamics do not change between measurements, and therefore, the computed bus impedance is not distorted. Experimental results are presented and used to demonstrate the effectiveness of the proposed method in the design of a stabilizing controller for a notional DC system using Positive Feed-Forward control (PFF).